• black icon of a bullhorn 30 years industry experience
  • black icon of three cubes Over 8,000 products in stock
  • Black icon of a clock Order by 16:00 and receive the next working day
ELECTROMEN

ELECTROMEN

Electromen - EM-324C

DC motor 2Q drive 12-24Vdc, 4A

  • 12-24Vdc, 4A continuous, 7A peak
  • Speed, direction, current limiting, soft start/stop and auto-reverse control
  • Limit switch inputs for end of travel
  • Compact, DIN rail mountable

Product description

EM-324 is a full bridge DC-motor starter. It is designed to work with DC-motor in applications where some special functions are needed.

Starter has adjustable acceleration and deceleration ramps, which make possible the smooth starts and stops. Adjustable current limit

protects motor against overcurrent and it can also be used as an end-stop. This device has also two settable speeds, which are usefull

in positioning applications. Control inputs FW and BW start the forward and backward run. STOP is for the motor shut-down but there are also available individual limit inputs for FW and BW directions. SPEED-2 input activates preset speed-2, but it can also be used as input for analog speed control signal 0-5V. FAULT terminal has at the same time input and output function, the pin is normally high, but is pulled down in overheat and conditionally also in current trip situation. If FAULT-line is pulled down externally it will cause a stop and prevent the new start. For example, it is possible to link fault pins of several units together and achieve a synchronous stop.

There are two selectable control modes, continuous and impulse. In continuous mode the motor runs as long as the control is active.

In impulse mode a short comand starts the motor, and only a new impulse will change the status. There is also few special settings

start-kick and auto reverse. The card has selectable input logics. Inputs are divided in two groups, control and limit -inputs. Groups can be individually set for NPN or PNP logic. The parameters are set with EM-236 interface unit. Operation of the controller and some of its

functional values can also be monitored with EM-236 interface unit.

 

FEATURES

- small size

- high current output

- current limit

- zero current limit

- overvoltage brake

- speed setting

- flexible control inputs

- impulse / continuous mode

- rail base mountable

- 2KHz or 16kHz pwm frequency

- for motor 5-50W

- digital parameter setting

 

 

* Motor current cont. max. 3A, peak 7A ( @ 16kHz Ta >50°C )

Motor current cont. max. 4A, peak 7A ( @ 2kHz Ta >50°C )

Part

EM-324C

Technical data

Analogue input 0-5V
Control type Speed, Direction, Torque, Soft start / stop
Current setting range 0.1-5 A
Dimensions length x width x height 32x72x18mm mm
Logic input high >4V = ON
Logic input low <1V = OFF
Max continuous current *4 A
Mounting DIN rail
Operating temperature -40°C...+60°C
Peak current 7 A
PWM frequency 2kHz/16kHz
Suitable engine DC
Supplier Electromen
Supply voltage 12 V DC, 24 V DC
Weight 25 g
Contact us

If you need any help, you can contact us in one of the following ways:

0116 284 9900

Send an e-mail

Use live chat